ryanrs Posted September 2, 2005 Share Posted September 2, 2005 i got me 2.0 ecu to fit to my 1.8 Si ..its a early 1997 p-reg. its a eec-iv 60pin. but when reading the guide to swapping the wires over, the colors of my wires dont tally up to the guides... ie, if it says pin 22 brown/red, mine isnt, its orange and yellow? also , where is the Red and black wire supposed to go, cos me tag fell off! Link to comment Share on other sites More sharing options...
Ex-Finesse Posted September 2, 2005 Share Posted September 2, 2005 Look at my guide. It's pinned at the top of the mech. section. Wiring varied many times over escorts. The colour of the wires is unimportant. Link to comment Share on other sites More sharing options...
ryanrs Posted September 2, 2005 Author Share Posted September 2, 2005 thanx ex-fienness , i used DRAVEN's one before i red ur post.. it wouldnt start at 1st, but, just turned out the earth i used for the pin32 , wasnt a good earth, i wired it to the ciggy lighter, as i no its a decent earth, and it started 1st time.(obviously ill wire it in properly later) it does narrr'f tickover better now! Link to comment Share on other sites More sharing options...
DRAVEN Posted September 3, 2005 Share Posted September 3, 2005 thanx ex-fienness , i used DRAVEN's one before i red ur post.. it wouldnt start at 1st, but, just turned out the earth i used for the pin32 , wasnt a good earth, i wired it to the ciggy lighter, as i no its a decent earth, and it started 1st time.(obviously ill wire it in properly later) it does narrr'f tickover better now!<{POST_SNAPBACK}> I never did a ECU guide, I did a guide to put the full Mk6 dash in to a mk6(clock wiring diagram) Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now