james08 Posted November 3, 2012 Share Posted November 3, 2012 got a diesel van that the heaters dont go hot on, they work on all speeds but only do cold any ideas? Link to comment Share on other sites More sharing options...
etrebus Posted November 3, 2012 Share Posted November 3, 2012 got a diesel van that the heaters dont go hot on, they work on all speeds but only do cold any ideas?is the engine getting warm? and are the pipes going to the matrix getting warm ?could also try pulling off both heater matrix hoses and flushing with a hose pipe have known them to block up soild especially if the coolant is a bit dirty Link to comment Share on other sites More sharing options...
james08 Posted November 3, 2012 Author Share Posted November 3, 2012 engine was deffo warm id been out in it for nearly 2 hours, ill try the pipes tomorrow Link to comment Share on other sites More sharing options...
james08 Posted November 4, 2012 Author Share Posted November 4, 2012 checked the pipes going to the matrix, left hand pipe gets hot but right hand pipe stays cold, any ideas? Link to comment Share on other sites More sharing options...
etrebus Posted November 4, 2012 Share Posted November 4, 2012 checked the pipes going to the matrix, left hand pipe gets hot but right hand pipe stays cold, any ideas?then to me its looking more like the matrix is blocked ,worth pulling off the hoses and flushing it out .if the coolant was flowing othrough the matrix both pipes would be warm Link to comment Share on other sites More sharing options...
james08 Posted November 4, 2012 Author Share Posted November 4, 2012 ill give that a go tomorrow then, im assuming a hose will be fine to flush it out? Link to comment Share on other sites More sharing options...
etrebus Posted November 4, 2012 Share Posted November 4, 2012 ill give that a go tomorrow then, im assuming a hose will be fine to flush it out?yes ,the water should flow easy through it (you are going to get wet)flush it from both sides of the matrix keep changing from side to side until it runs clean good luck ill give that a go tomorrow then, im assuming a hose will be fine to flush it out?yes ,the water should flow easy through it (you are going to get wet)flush it from both sides of the matrix keep changing from side to side until it runs clean good luck if this cures it dont forget to put antifreeze back in as its not just antifreeze its also prevents corrosion Link to comment Share on other sites More sharing options...
james08 Posted November 4, 2012 Author Share Posted November 4, 2012 ill give that a go tomorrow, got some anti freeze waiting to go in when this is sorted Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now