Blimey Posted July 29, 2005 Share Posted July 29, 2005 If i wanted a new point in my car to ground my amp, do i just need to drill a hole in the boot floor? do i need to do anything else to it? and then just use a self tapping screw to go through it right? Link to comment Share on other sites More sharing options...
simonh1 Posted July 30, 2005 Share Posted July 30, 2005 Why not use one of the seatbelt anchor points.........saves drilling through the rust protection. Link to comment Share on other sites More sharing options...
F1ACK Posted July 30, 2005 Share Posted July 30, 2005 I used the bolts that hold the suspension in, (the 3 smaller bolts), just get a bit connector, take a bolt out, put it on and put the bolt back, worked fine for me, (think I ground some of the paint away just to be safe) Link to comment Share on other sites More sharing options...
IAN.D Posted July 30, 2005 Share Posted July 30, 2005 I'd just self tapper it in to be honest unless you've thousands of watts it'll be fine. It's more important to keep the earth lead as short as possible and away from signal wires (RCA). Just don't use a 2 inch screw!!! and see whats behind the metal you're screwing into! Link to comment Share on other sites More sharing options...
father_ged Posted July 31, 2005 Share Posted July 31, 2005 a good thing to do, is to sand away paint that will be directly underneath where the wire is going to be screwed, so its bare metal. this will make a better contact for the wire. also, when its all screwed down, spray some paint over it all so that its completely insulated again, and should prevent rust!! Link to comment Share on other sites More sharing options...
geordie_aaron Posted July 31, 2005 Share Posted July 31, 2005 i wouldn't screw INTO the car at all, a very bad idea IMO as said above rust ETC will get into itI've also done the same as F1ACK Link to comment Share on other sites More sharing options...
Stu Posted July 31, 2005 Share Posted July 31, 2005 Making a new ground point is fine, as long as you treat it properly afterwards. Sure, drilling a hole and leaving it untreated will rust Link to comment Share on other sites More sharing options...
RickH Posted August 2, 2005 Share Posted August 2, 2005 Take a leaf out of simons book and use the seatbelt anchor points as an earthing point, exactly what i have done. Link to comment Share on other sites More sharing options...
Blimey Posted August 2, 2005 Author Share Posted August 2, 2005 I tried the seat belt anchors but the bold was too chunky, the ground ring wouldnt fit round it, will give the suspension screws a go 2morrow. Link to comment Share on other sites More sharing options...
geordie_aaron Posted August 3, 2005 Share Posted August 3, 2005 change the rings? not a huge job Link to comment Share on other sites More sharing options...
Al_scort16i Posted August 4, 2005 Share Posted August 4, 2005 follow the blue cable on the right, i found an earth point there Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now